Rebuild Kit for Paxton SN93
IMPORTANT NOTE: REMOVE GREASE FROM BEARINGS BEFORE INSTALLATION!
This kit comes complete with all the hard parts in a supercharger (not the casing).
Including:
(1) Brass Ball Carrier
(1) Impeller Shaft
(5) Drive Balls
(2) Main Shaft Bearings
(1) Front Seal
(1) Rear Seal (VR4 Style)
(2) Casing O-Rings
(1) Dipstick O-Ring
Impeller & Race Shims
(1) Oil Pump Screen/Filter
(2) Races
This kit is 100% Paxton parts with the special rear seal that's made of carbon fiber you cant find anywhere else except Paxton, so watch out for those trying to pass some fake stuff off to you. The rear seal has to withstand 30,000-40,000 RPMs and no body makes it!
**NOTE: Replacing a hard part like this might require shimming your unit. Professional installation recommended!**
This kit comes complete with all the hard parts in a supercharger (not the casing).
Including:
(1) Brass Ball Carrier
(1) Impeller Shaft
(5) Drive Balls
(2) Main Shaft Bearings
(1) Front Seal
(1) Rear Seal (VR4 Style)
(2) Casing O-Rings
(1) Dipstick O-Ring
Impeller & Race Shims
(1) Oil Pump Screen/Filter
(2) Races
This kit is 100% Paxton parts with the special rear seal that's made of carbon fiber you cant find anywhere else except Paxton, so watch out for those trying to pass some fake stuff off to you. The rear seal has to withstand 30,000-40,000 RPMs and no body makes it!
**NOTE: Replacing a hard part like this might require shimming your unit. Professional installation recommended!**
